Imperial Carbide Centers cover the requirements for a wide range of workpiece center holes. They reduce costs by eliminating the need for special dead centers. Knockout ends are hardened on carbide tipped dead centers. Applying a Moly EP632 grease on the point will reduce friction and wear.
Unit of Measure
Material |
N/A Large Carbide Point |
Accuracy |
N/A ± .00005 |
Taper |
N/A 12 |
A - Point Diameter |
N/A 1.797 Inch |
Note |
N/A Carbide Diameter |
H - Height above Center Line |
N/A 0.250 Inch |
K - Gage Line to Point |
N/A 4.000 Inch |
L - Length of Cut Out |
N/A 3.250 Inch |
T - Carbide Tip Diameter |
N/A 1.250 Inch |
Series |
N/A Imperial Large Carbide |
Available Points |
N/A Carbide Tipped Half Dead Center |
