Riten Industries Inc. - Type 41 / Driving Diameter Range: 0.24 - 0.75 Inch

The Type 41 Series allows a driving diameter of 0.24" to 0.75". The driving pins move independently to allow a five-degree pitch of the end face of the work-piece. The mechanical compensation and lock down center point allow a constant length to be held from center to the taper. The Type 41 Series is available in 3, 4,and 5 morse taper designs as well as a flange mount. Chuck mounting can be achieved as described in the mounting procedures. View Catalog Page

Request Information Search by Specification

Unit of Measure

Items	4103-P4101C4101 Offset Pin Style Counterclockwise 3 Mounting Style Face Driver	4103-P4102C4101 Offset Pin Style Clockwise 3 Mounting Style Face Driver	4103-P4103C4101 Half Offset Pin Style Counterclockwise 3 Mounting Style Face Driver	4103-P4104C4101 Half Offset Pin Style Clockwise 3 Mounting Style Face Driver	4103-P4105C4101 Full Width Pin Style Counterclockwise 3 Mounting Style Face Driver
Tool Series/Type	N/A 41
Design Type	N/A Mechanical, TIR less than .001
Mounting Style	N/A 3
MOUNT	N/A 03
Drive Pin Part #	N/A P4101	N/A P4102	N/A P4103	N/A P4104	N/A P4105
Pin Style	N/A Offset	N/A Offset	N/A Half Offset	N/A Half Offset	N/A Full Width
STYLE	N/A 1	N/A 1	N/A 2	N/A 2	N/A 3
Driving Diameter	N/A 0.240 Inch	N/A 0.240 Inch	N/A 0.430 Inch	N/A 0.430 Inch	N/A 0.750 Inch
Rotation	N/A Counterclockwise	N/A Clockwise	N/A Counterclockwise	N/A Clockwise	N/A Counterclockwise
ROTAT	N/A R	N/A L	N/A R	N/A L	N/A R
No. of Pin	N/A 3
Pin Edge Length "L"	N/A 0.06 Inch	N/A 0.06 Inch	N/A 0.16 Inch	N/A 0.16 Inch	N/A 0.32 Inch
Center Point Part #	N/A C4101
Center Hole Diameter Range (Inch)	N/A 0 to .12
Driving Diameter Ranges "G"	N/A 0.24 - 0.75 Inch
Min. Raw Stock Size Range "S"	N/A 0.276 Inch
Max. Raw Stock Size Range "S"	N/A 1.500 Inch
Tail Stock Force	N/A 680 lbs	N/A 680 lbs	N/A 720 lbs	N/A 720 lbs	N/A 800 lbs
Dim. "A"	N/A 3.430 Inch
Dim. "B"	N/A 5.830 Inch
Dim. "C"	N/A 1.890 Inch
Dim. "b"	N/A 60.000 Degree
Dim. "N"	N/A 0.870 Inch
Notes	N/A Minimum Stock size should be .030 larger than driving diameter. Maximum Stock size should be no more than 2X driving diameter.