The Type 42 Series allows a driving diameter of 0.43" to 0.79". The driving pins move independently to allow a five-degree pitch of the end face of the work-piece. The mechanical compensation and lock down center point allow a constant length to be held from center to the taper. The Type 42 Series is available in 3, 4,and 5 morse taper designs as well as a flange mount. Chuck mounting can be achieved as described in the mounting procedures. View Catalog Page
Unit of Measure
Specifications
Tool Series/Type |
N/A 42 |
Design Type |
N/A Mechanical, TIR less than .001 |
Mounting Style |
N/A Flange Mount |
MOUNT |
N/A FM |
Drive Pin Part # |
N/A P4201 |
Pin Style |
N/A Offset |
STYLE |
N/A 1 |
Driving Diameter |
N/A 0.430 Inch |
Rotation |
N/A Counterclockwise |
ROTAT |
N/A R |
No. of Pin |
N/A 3 |
Pin Edge Length "L" |
N/A 0.06 Inch |
Center Point Part # |
N/A C4204 |
Center Hole Diameter Range (Inch) |
N/A .335 to .472 |
Driving Diameter Ranges "G" |
N/A 0.43 - 0.79 Inch |
Min. Raw Stock Size Range "S" |
N/A 0.472 Inch |
Max. Raw Stock Size Range "S" |
N/A 1.580 Inch |
Tail Stock Force |
N/A 700 lbs |
Dim. "A" |
N/A 4.528 Inch |
Dim. "B" |
N/A 5.348 Inch |
Dim. "C" |
N/A 1.650 Inch |
Dim. "b" |
N/A 60.000 Degree |
Dim. "N" |
N/A 0.240 Inch |
Notes |
N/A Requires Custom Drive Pins. Minimum Stock size should be .030 larger than driving diameter. Maximum Stock size should be no more than 2X driving diameter. |
Remarks |
N/A Clockwise use Left hand pins, CounterClockwise use Right-hand Pins |
