The Type 44 Series allows a driving diameter of 1.02" to 1.42". The driving pins move independently to allow a five-degree pitch of the end face of the work-piece. The mechanical compensation and lock down center point allow a constant length to be held from center to the taper. The Type 44 Series is available in 4 and 5 morse taper designs as well as a flange mount. Chuck mounting can be achieved as described in the mounting procedures. View Catalog Page
Unit of Measure
Specifications
Tool Series/Type |
N/A 44 |
Design Type |
N/A Mechanical, TIR less than .001 |
Mounting Style |
N/A 5 |
MOUNT |
N/A 05 |
Drive Pin Part # |
N/A P4403 |
Pin Style |
N/A Half Offset |
STYLE |
N/A 2 |
Driving Diameter |
N/A 1.220 Inch |
Rotation |
N/A Counterclockwise |
ROTAT |
N/A R |
No. of Pin |
N/A 6 |
Pin Edge Length "L" |
N/A 0.30 Inch |
Center Point Part # |
N/A C4602 |
Center Hole Diameter Range (Inch) |
N/A .512 to .709 |
Driving Diameter Ranges "G" |
N/A 1.02 - 1.42 Inch |
Min. Raw Stock Size Range "S" |
N/A 0.552 Inch |
Max. Raw Stock Size Range "S" |
N/A 2.840 Inch |
Tail Stock Force |
N/A 2140 lbs |
Dim. "A" |
N/A 3.150 Inch |
Dim. "B" |
N/A 6.970 Inch |
Dim. "C" |
N/A 2.760 Inch |
Dim. "b" |
N/A 60.000 Degree |
Dim. "N" |
N/A 0.550 Inch |
Notes |
N/A Requires Custom Drive Pins. Minimum Stock size should be .030 larger than driving diameter. Maximum Stock size should be no more than 2X driving diameter. |
Remarks |
N/A Clockwise use Left hand pins, CounterClockwise use Right-hand Pins |
